Motion Control – DC and Brushless Servo Motor Driver From MotiCont – A Motion Company

DC Servo Motor Drive from MotiCont - A Motion Company

Van Nuys, CA – This series of drivers is a high performance, cost effective servo motor driver to implement intelligent motion control. The driver incorporates an advanced architecture and surface mount technology to achieve an exceptional power density.

This series is designed to drive voice coil, brush-type and brushless DC motors at a high switching frequency. They receive step and direction signals or analog signal from motion controller.


* Runs DC and Brushless Servo Motors
* Four Quadrant Regenerative Operation
* Space Vector Modulation (SVM) Technology
* Fully Digital State-of-the-art Design
* Programmable Current, Velocity and Position Loops Gain Settings
* Fully Configurable Current, Voltage, Position Limits
* PID + FF Position Loop
* Up to 12 Amp Motor Output
* +20 VDC to +80 VDC Power Supply
* Protected Against Over Current
* Built-in Signal Generator, Sinusoidal, Square Wave and Triangular
* 20 KHz PWM Frequency
* No Tachometer Feedback Needed
* 0 ºC to 70 ºC Operating Temperature
* Modular 2-Piece Power, Motor, Signal Connector

Modes of Operation

* Current
* Velocity
* Position

Command Source

* Encoder Following
* ±10 V Analog
* Opto-isolated Step and Direction

Feedback Supported

* Hall Effect Sensor
* Incremental Encoder
* ±10 V Analog
* Auxiliary Incremental Encoder

For additional information contact MotiCont, “A Motion Company” at 6901 Woodley Avenue, Van Nuys, CA 91406, USA; Tel: (888) 785-1804, Fax: (818) 785-5713, E-Mail: or visit the website at

Both comments and pings are currently closed.
Powered by WordPress | Designed by: Virtual Dedicated Servers | Compare Top WordPress Themes, wordpress 4 themes and